$1,112.50
This product is esigned with a patented Up-flow technology which prevents the accumulation of air inside the filter housing keeping the filter operating at 100%.
Features
– 304 Stainless steel construction, standard
– Electropolished finish, standard
– 150 psi (10.3 bar) pressure rating
– Flow rates up to 800 GPM
– All filter housings hydrostatically tested
– Easy cartridge installtion, removal and service
– Individual studs for safe, secure lid closure
– Extensive choice of cartridge micron ratings and media
– Manufactured in the USA
Options
– 316 Stainless steel
– Chemical resisten coating
– Flanged options on HIF 24, HIF 42, HIF 75 and HIF 100
Applications
– Commercial/Residential Drinking Water – Industrial Waste Water Treatment
– Cooling Tower Filtration – Reverse Osmosis Pre-Filtration
– Process Water – Ground water remidiation
– Surface Water Treatment Rule (SWTR) LT2 – Utility Water
| Filter Model | HIF 7 |
| Height | 19-1/2″ |
| Diameter |
13″ |
| Leg Width |
13″ |
| Inlet Height |
3-1/2″ |
| Service Height |
35″ |
| Inlet/Outlet |
1-1/2″ NPT |
| Drain Size NPT |
1″ |
| Flow Rate* (GPM) |
Up to 30 |
| Flow Rate* (LPM) |
Up to 113 |
| Flow Rate* (M3/HR) |
Up to 7 |
| Cartridges |
(7) 9-3/4″ “Singles” |
* Flow rates shown are above for guidelines only. Actual flow rates are based on cartridge type, micron rating, viscosity, solids content and a number of other factors. For complete flow and pressure drop information please refer to your cartridge manufacturer guidelines.
– Filter Vessel/Metal Components – 304 stainless steel, electropolished for increased resistance to corrosion
– Holding/Lifting Rods, Standpipes and Pipe Caps – CPVC, standard models; 304 stainless steel for All Stainless models
– Rim Gaskets – EPDM, standard; Buna-N, Viton Available
– O-Rings – Buna-N Standard; EPDM, Viton Available
– Bottom Seals – natural gum rubber, standard; EPDM, Viton Available
– Pressure – rated for presure to 150 psi (10.3 bar) max
– Temperature – rated for 140°F (60°C) with CPVC rods, pipe caps, standpipes and standard Harmsco cartridges; to 200°F (93°C) for all stainless models with stainless steel rods, pipe caps and standpipes and Harmsco High-temp cartridges
– Wing Nuts – brass; optional brass hex nuts and stainless steel flat washers
